Finish-thompson PFM/PFP/PFV Vapor Seal and Bearing Replacement User Manual

PPFFMM//PPFFPP//PPFFVV VVaappoorr SSeeaall aanndd BBeeaarriinngg RReeppllaacceemmeenntt IInnssttrruuccttiioonnss DDiissaasssseemmbblliinn

Lightly tap the bottom of the shaft on the ground. This will partially push the bearing from the pump head. Picture showing bearing a

Picture illustrating bearing completely removed from pump head. Picture illustrating shaft with bearing assembly, impeller housing with lower i

RReeppllaacciinngg vvaappoorr sseeaall Top view of pump head. Vapor seal seen in center. Bottom view of pump head. Using any typ

Install new vapor seal with tapered side up. Using no larger than a 3/4" diameter rod, tap seal until fully seated in counter bore.

Simply thread shaft onto new bearing assembly (turn clockwise). Note: Hole in shaft should be opposite from bearing. RReeaasssseemmbblliinngg

Carefully turn the shaft and head upside down and press the bearing assembly into the head. This should press in by hand rather easily. Sp

Insert outer tube over shaft assembly. The outer tube will want to “hang up” on the guide bearing. Slide outer tube all the way to the head

and with your other hand screw the impeller onto the pumps shaft (turn clockwise). Install impeller housing cover (turn counterclockwise). Pum